Heraldo de Madrid - Gold Terra Wedge Drilling Progressing Well at High-Grade Gold target, Campbell Shear, Con Mine Option Property, NWT

The objective of the 2025 wedge hole drilling program is to continue testing for high-grade gold in the CS (past production of 5.1 Moz @ 16 g/t, refer to the Oct. 21, 2022 Technical Report) on the Con Mine below the historic Con Mine underground workings. The CMO Property is under option from a subsidiary of Newmont Corporation and is 100% acquirable by the Company upon fulfillment of certain conditions set out in the CMO Property Option agreement, as reported in the Company's news release dated November 22, 2021. The target is located downdip from the 5.1 Moz mined gold deposit plunging steeply to the south between elevation 1,900 metres (Robertson shaft depth) and 2,600 metres.

Chairman and CEO, Gerald Panneton, commented, "The wedge drilling is progressing well utilizing a very efficient and cost-effective way to assess the CS at depth. The objective of our first wedge hole is to intersect the CS and extend the high-grade gold potential at a vertical depth of 2,500-2,600 metres below surface, or approximately 600 metres below the current depth of the Robertson Shaft. Once we complete the first wedge, we will step up laterally 30-50 metres on each side of the first intersection. This target below the Robertson shaft has the potential for multi-million ounces as we are down plunge from a 5.1 Moz deposit @ 16 g/t Au mined historically at a rate of 1 Moz per 200 metres vertical on average."

Wedge Hole GTCM24-056A Highlights

Figure 1 below is a cross-section showing the master hole GTCM24-056 from which wedge hole GTCM25-056A has been set up to target the CS at depth. The CS was initially intersected at depth in hole GTCM23-055, which intersected 12.63 g/t Au over 1.7m in the CS structure approximately 150 metres below the Con Mine workings, demonstrating the potential of the CS is well open at depth. Figure 1a, further below shows wedge hole GTCM24-056A in greater detail.

IMDEX of Sudbury, a contract directional drilling crew, is currently utilizing the DeviDrill cutting tool to deviate the hole with the purpose of flattening the dip to intersect the CS as shown in Figure 1 below. After setting up a steel wedge down the hole at a depth of 1,950 metres, the tool was used to orientate the hole from 2,005 to 2,081 metres, successfully achieving a flattening from 82 degrees down to 69 degrees. Drilling was then performed from 2,081 to 2,132 metres without the tool. The second deviation, and possibly the last one, started on Monday February 24^th at a depth of 2,132 metres. The hole is currently at 2,162 metres with a dip of 66.5 degrees, and when a 54 degrees dip is reached, the deviation tool will be stopped, and drilling will continue until the CS is intersected.

Figure 1 - Cross section showing master hole GTCM24-056, the hanging granite wall zone, the Con Shear, and the gold potential window of the CS targeted by wedge hole GTCM25-056A.

Figure 1a - Cross section showing the CS gold potential window targeted by wedge hole GTCM25-056A.

Meet with Gold Terra at the PDAC 2025

Gold Terra is pleased to invite investors and shareholders to meet with management at the PDAC Conference, Investors Exchange Booth # 2304, March 2-5, 2025, South Building, Metro Toronto Convention Centre, Toronto. On Monday, March 3, 2025, at 3:00 PM EST, Chairman and CEO Gerald Panneton will be presenting at the PDAC 2024 Corporate Presentation Forum for Investors (CPFI) session located in the new Investment Hub theatre, in Hall E, on the Investors Exchange show floor, 800 level.

The 2025 deep drilling program aims to expand the September 2022 initial Mineral Resource Estimate ("MRE") (see September 7, 2022, press release) of 109,000 Indicated ounces of contained gold and 432,000 Inferred ounces of contained gold between surface and 400 metres below surface along a 2-kilometre corridor of the Campbell Shear (October 21, 2022 MRE titled "Initial Mineral Resource Estimate for the CMO Property, Yellowknife City Gold Project, Yellowknife, Northwest Territories, Canada" by Qualified Person, Allan Armitage, Ph. D., P. Geo., SGS Geological Services, which can be found on the Company's website at https://www.goldterracorp.com and on SEDAR at www.sedar.com.

The technical information contained in this news release has been reviewed and approved by Joseph Campbell, a Qualified Person as defined in National Instrument 43-101 - Standards of Disclosure for Mineral Projects and Senior Technical Advisor for the Company.

About Gold Terra

The Yellowknife Project (YP) encompasses 918 sq. km of contiguous land immediately north, south and east of the City of Yellowknife in the Northwest Territories. Through a series of acquisitions, Gold Terra controls one of the six major high-grade gold camps in Canada. Being within 10 kilometres of the City of Yellowknife, the YP is close to vital infrastructure, including all-season roads, air transportation, service providers, hydro-electric power, and skilled tradespeople. Gold Terra is currently focusing its drilling on the prolific Campbell Shear, where approximately 14 Moz of gold has been produced, (refer to Gold Terra Oct 21, 2022, Technical Report) and most recently on the Con Mine Option (CMO) property claims immediately south of the past producing Con Mine which produced 6.1 Moz between the Con, Rycon, and Campbell shear structures (1938-2003).

The YP and CMO properties lie on the prolific Yellowknife greenstone belt, covering nearly 70 kilometres of strike length along the main mineralized shear system that hosts the former-producing high-grade Con and Giant gold mines. The Company's exploration programs have successfully identified significant zones of gold mineralization and multiple targets that remain to be tested which reinforces the Company's objective of re-establishing Yellowknife as one of the premier gold mining districts in Canada.

Visit our website at www.goldterracorp.com.

For more information, please contact:

Gerald Panneton, Chairman & CEO
[email protected]

Mara Strazdins, Investor Relations
Phone: 1-778-897-1590 | 416-710-0646
[email protected]

Neither the TSX Venture Exchange nor its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange) accepts responsibility for the adequacy or accuracy of this release.

Information Concerning Estimates of Mineral Resources

Mineral Resources that are not Mineral Reserves do not have demonstrated economic viability. Therefore, investors are cautioned not to assume that all or any part of an Inferred Mineral Resource could ever be mined economically. It cannot be assumed that all or any part of "Measured Mineral Resources," "Indicated Mineral Resources," or "Inferred Mineral Resources" will ever be upgraded to a higher category. The Mineral Resource estimates contained herein may be subject to legal, political, environmental or other risks that could materially affect the potential development of such mineral resources. Refer to the Technical Report, once filed, for more information with respect to the key assumptions, parameters, methods and risks of determination associated with the foregoing.

Cautionary Note to United States Investors

The Company prepares its disclosure in accordance with the requirements of securities laws in effect in Canada, which differ from the requirements of U.S. securities laws. Terms relating to Mineral Resources in this news release are defined in accordance with NI 43-101 under the guidelines set out in CIM Definition Standards on Mineral Resources and Mineral Reserves, adopted by the Canadian Institute of Mining, Metallurgy and Petroleum Council on May 19, 2014, as amended ("CIM Standards"). The U.S. Securities and Exchange Commission (the "SEC") has adopted amendments effective February 25, 2019 (the "SEC Modernization Rules") to its disclosure rules to modernize the mineral property disclosure requirements for issuers whose securities are registered with the SEC under the U.S. Securities Exchange Act of 1934. As a result of the adoption of the SEC Modernization Rules, the SEC will now recognize estimates of "Measured Mineral Resources", "Indicated Mineral Resources" and "Inferred Mineral Resources", which are defined in substantially similar terms to the corresponding CIM Standards. In addition, the SEC has amended its definitions of "Proven Mineral Reserves" and "Probable Mineral Reserves" to be substantially similar to the corresponding CIM Standards.

U.S. investors are cautioned that while the foregoing terms are "substantially similar" to corresponding definitions under the CIM Standards, there are differences in the definitions under the SEC Modernization Rules and the CIM Standards. Accordingly, there is no assurance any Mineral Resources that the Company may report as "Measured Mineral Resources", "Indicated Mineral Resources" and "Inferred Mineral Resources" under NI 43-101 would be the same had the Company prepared the Mineral Resource estimates under the standards adopted under the SEC Modernization Rules. In accordance with Canadian securities laws, estimates of "Inferred Mineral Resources" cannot form the basis of feasibility or other economic studies, except in limited circumstances where permitted under NI 43-101.

Cautionary Note Regarding Forward-Looking Information

Certain statements made and information contained in this news release constitute "forward-looking information" within the meaning of applicable securities legislation ("forward-looking information"). Generally, this forward-looking information can, but not always, be identified by use of forward-looking terminology such as "plans", "expects" or "does not expect", "is expected", "budget", "scheduled", "estimates", "forecasts", "intends", "anticipates" or "does not anticipate", or "believes", or variations of such words and phrases or statements that certain actions, events, conditions or results "will", "may", "could", "would", "might" or "will be taken", "occur" or "be achieved" or the negative connotations thereof.

All statements other than statements of historical fact may be forward-looking information. Forward-looking information is necessarily based on estimates and assumptions that are inherently subject to known and unknown risks, uncertainties and other factors that may cause the actual results, level of activity, performance or achievements of the Company to be materially different from those expressed or implied by such forward-looking information. In particular, this news release contains forward-looking information regarding the current drilling on the Campbell Shear, potentially adding ounces to the Company's current YCG mineral resource, and the Company's objective of re-establishing Yellowknife as one of the premier gold mining districts in Canada.

There can be no assurance that such statements will prove to be accurate, as the Company's actual results and future events could differ materially from those anticipated in this forward-looking information as a result of the factors discussed in the "Risk Factors" section in the Company's most recent MD&A and annual information form available under the Company's profile at www.sedar.com.

Although the Company has attempted to identify important factors that would cause actual results to differ materially from those contained in forward-looking information, there may be other factors that cause results not to be as anticipated, estimated or intended. The forward-looking information contained in this news release is based on information available to the Company as of the date of this news release. There can be no assurance that such statements will prove to be accurate, as actual results and future events could differ materially from those anticipated in such statements. All of the forward-looking information contained in this news release is qualified by these cautionary statements. Readers are cautioned not to place undue reliance on forward-looking information due to the inherent uncertainty thereof. Except as required under applicable securities legislation and regulations applicable to the Company, the Company does not intend, and does not assume any obligation, to update this forward-looking information.

SOURCE: Gold Terra Resource Corp.

View the original press release on ACCESS Newswire

S.Llorente--HdM